Korg Trinity + Gotek with HxC problem

[Jeff]

Hi Jeff,

I have the same results with the MO jumper set.

Are you waiting some seconds after the image selection ?

[Jeff]

Try this : Make a contact between the S1 jumper and the ground. This will permanently select the gotek (led green always lit) but this have solved this issue with the previous user.

[alchemist]

Hi Jeff,

I have the same results with the MO jumper set.

Are you waiting some seconds after the image selection ?

Yes. No action cannot be done (click on file or open the menu), the system says always "medium changed".

Try this : Make a contact between the S1 jumper and the ground. This will permanently select the gotek (led green always lit) but this have solved this issue with the previous user.

I will try it, but this is not a solution for me. Can't it be done through a software feature?
Could the official HxC drive work? In that case, I will sell my gotek and buy a HxC.

[Jeff]

Why this is not a solution ?
I can do this in software, but a small wire is an immediate solution

[Jeff]

Try this firmware :
https://hxc2001.com/vrac/HxCUSBFEUNGATED.UPD
No jumper needed with this one.

------------------------------------------------------------------------------------------------------------------------------
EDIT : This file can now be generated from the custom firmware page :

https://hxc2001.com/custom_fw/

Set "Non gated mode" and request the firmware (see the last "Build order" section).
------------------------------------------------------------------------------------------------------------------------------

[alchemist]

Thank you Jeff, I will try it this evening

[alchemist]

Jeff,

IT'S WORKING !!!!



Thank you very much !

Is there a "beer" button, you owe a full pack of it !