I've been trying to get a Revision F HxC to work with an Akai S3000. I'm so close to getting it to function but I'm sure there's something in the settings I'm not doing right.
I made an image of the original Akai sounds disk with omniflop, and then transferred it to the SD card following all the settings that are suggested in a post below for the Akai S20. I assumed the S20 was of a similar age and must use a virtually identical disk system.
The S3000 "sees" the samples and programs (they're displayed on the Akai's screen) but can't load them, all you get is a brief click from the drive and then the sampler becomes unresponsive. Power off is the only remedy.
I do realise that the Akai S3000 is listed by Lotharek in the "should work" category rather than tested and working, but I took a chance as other Akais appeared to work successfully with the virtual drive.
Would be marvellous to get this up and running, 8 outputs and effects with 4gb of samples on one card is quite a decent hardware drum machine. Any help would be much appreciated
