DF0:unreadable

[odo]

df0:unreadable DF1 is working with switch 2 and i can get DF0 wroking if i use switch 5 (drive b) but the (normal) setting doesn't work
it's a slim version
Cheers
Marc

[odo]

No one ?
i updated the firmware a few times with no luke.

[Jeff]

Too few informations about your setup. Which amiga ? how many drive into the machine ? How do you use the emulator (with the file selector ?) ?
how is connected the emulator ?

[odo]

True

Amiga 1200 only hxc no external floppy drives.I use the normal amiga floppy cable and file selector.

[Jeff]

True

Amiga 1200 only hxc no external floppy drives.I use the normal amiga floppy cable and file selector.

So the hxc is inside the amiga ?

[odo]

Yes

[odo]

Can't find edit post so sorry for a new one

More info!
a1200 kickstart 3.1
blizzard 060 @50 128mb ram
RapidRoad Usb
indi mk2 not de CR
os3.5 CWB
Best A500 PSU
Bord 2b
2.5 ide hdd
total recap well don not by me


Also tried it on a other on with no luke
regards
Marc

[Jeff]

Hard to say. There is maybe an hardware problem. can you try the emulator on another machine ?

[torke1]

I have the exact same problem. I mount two demo images in slot 001. The drives show as DF0:???? and DF1:NDOS. If I swap the images, DF0 is still unreadable. I have an Amiga 500+ with kipper2k's A504IDE with three CF card partitions and the Gotek is mounted internally. HxC firmware v3.0.8.2a.

Has anyone found a solution to the problem?

[Arnie]

If you only use one emulated drive (DF0:), does it work as it should?

[torke1]

If you only use one emulated drive (DF0:), does it work as it should?

Is it possible to turn one drive off in hardware? Turning it off in the Manager does not work...

[Arnie]

Yes, just set the dip switch for the first drive [a] to on, leave off.

[odo]

Problem solved it was the dip switch soldered a wire (drive A DF0)