AKAI S950 Resistor soldering

[jon909]

Greetings,

I have limited knowledge electronically, just wanna check with the forum if this is the right way of soldering the resistor 2.2k ohm onto R12 position.



Thanks in advance.

[jon909]

Btw, the connector from the sampler doesnt seem to fit SD drive's connector as well as the floppy drive.

They are both 4 pin, the grooves on both connectors dont fit well with each other.

Any thoughts?

[Jeff]

Greetings,

I have limited knowledge electronically, just wanna check with the forum if this is the right way of soldering the resistor 2.2k ohm onto R12 position.



Thanks in advance.

This is ok, but the resistor case is a way too big.
Here is the right form factor:
http://www.rf-microwave.com/schede/images/00000317.jpg

[jon909]

Thanks Jeff for the info re the resistor , any advise on the connectors, they both dont seem to fit each other vey well. Did i get the right SD drive for my Akai ?

[Jeff]

Thanks Jeff for the info re the resistor , any advise on the connectors, they both dont seem to fit each other vey well. Did i get the right SD drive for my Akai ?

Yes. doesn't fit at all?
If yes you should contact Lotharek.