
After power OFF and ON, DF1 is visible.
THANKS
and without the harddrive ?Arnie wrote:No change for me, I still have to have a non booting Autoboot.hfe in df0: for DF1: to show up.
This is not an HxC problem. Just set the external drive jumper to DF2 and all should be fine._Jackie wrote:The second day of testing: It's OK, both drives from HXC work.
But there is something that can be improved.
When I connect an external drive to the Amiga computer should see it as DF2 (DF0 and DF1 emulates HXC).
However, the Amiga does not see the external drive, but DF1 from HXC working together with external DF2.
When reading a floppy disk with DF1, I hear it works external DF2, and vice versa.
Can it be improved? I know that I can turn off the emulation DF1 and then everything is ok, but I would like to emulate two drives from HXC plus the external DF2.
DF2 its real external Floppy Drive.
Have you read these messages ? :seldon wrote:Hi Jeff,
I'm still having problems with my HxC, I think I checked everything - power supply, updating procedure and it still doesn't work. There is only one issue to check - maybe my update file is damaged. Could you please verify that attached file I'm using is correct?
Jeff wrote:The firmware v2.0.2.2 is provided since some month without any problem.
Since i am very suspicious about your board bootloader & firmware (you shouldnt' have the buggy v2.0.1.3a...) , the thing to do is to exchange it. Lotharek will advice you.
Last try : Please post a picture of your board : i want to see the switches and the floppy cable.lotharek wrote:SELDON -- Please contact me to lotharek@lotharek.pl
Thanks for the feedback.seldon wrote:I just wanted to write, that all my problems have been solved. I received my HxC from Lotharek back and everything works as before, as well as both drives A and B. The problem was probably my SD card.