i have the following setup: Korg X2 with Gotek drive and HxC firmware (latest version), with OLED display attached. Adapter to 26pin, Jumper set to S0, no other jumper present on Gotek. Set to Shugart mode, system family set to Korg. Tried it also with no specific system family, doesn't matter.
I have a tried preparing a few .hfe files on disks, and some empty Dos 720kb disk files, so that I may get any kind of response from the synth. It has been hardware reset, so I need to upload the original data onto it.
However, regardless of which disk I "insert" into the Gotek, the Synth always tries to load the directory and stops with a "Data Error" message. I can see on the LCD that it does not try to access any tracks of the disk.
The same when I tell it to format the disk, there is a waiting message on the LCD of the X2, but the tracks of the disk are not accessed, it is not formatted.
Edit: Forgot: The LED on the Gotek does not light up at all, too.
Do I need to prepare a special configuration file for it to be able to access the disks?
And: can anyone point me to some help how to get the X3 preload files onto a virtual disk? You can only download the pure files from the Korg website, but when you format a disk in the synth, apparently it is not readable anymore by the HxC FloppyEmulator software (only as raw), although a normal PC can read and write to a Korg formatted DD disk.
Thanks in Advance! Let's save this nice old synth!
