Acorn A3000

[stomachcontents]

Jeff!

Your suggestion worked! IT WORKS!! HAHA! So happy!

So is this something I should have changed in my config file or is the only way to fix it to do the config on the actual HxC?

By the way I have a A3010, not a A3000. Posted here because the problem sounded similar to the issues some people had with the A3000.

Here's a pic of my drive in case it helps..

Thanks again Jeff!!

[alienkidmj12]

Does this mean hxc works on a3000

[Jeff]

Does this mean hxc works on a3000

For sure it does. Just a question of setting.

[alienkidmj12]

can someone help me out configuring hxc2001, im struggling here,

i can get it to recognise my 8gb card to start with, so im doing a full format

dave

[alienkidmj12]

still unable to see files, all i get is choose a file, i know there are lots of adf files on there just cant see them, ive managed to install the latest beta firmware though.

[Jeff]

still unable to see files, all i get is choose a file, i know there are lots of adf files on there just cant see them, ive managed to install the latest beta firmware though.

Which HxC are you talking about exactly ?

[alienkidmj12]

i have a drive from lotharek, type f connected to the acorn a3000. i have jumpers id0a through id3a set to on, i have "no disk" message when trying to read disk, if i set first jumper on it seems to read sometimes but then locks up the os not having much luck here folks, does this support a3000 or not

[alienkidmj12]

got it working on custom mode, pin 2 and 34 to low, also pin id0a set to on only.

[number-one]

Hello I am newbie user of an Archimede A3010 4MB Ram without hard disk.
I have 1 slim HXC and 1 REV C HXC.

I am lost, what are the jumpers, floppy cable and software settings to read Acorn Disk Image ?