Skip SD card detection possible ?

[freshworks]

Hi,

Is there any possibility to skip te SD card detection, so i mean when i put the SD card in a floppydisc cable, i don't have the presence and protection switch ?

How can i simulate these or make a simple workaround ?

Thanks and greetz,
Jasper

[Jeff]

Hi,

Is there any possibility to skip te SD card detection, so i mean when i put the SD card in a floppydisc cable, i don't have the presence and protection switch ?

How can i simulate these or make a simple workaround ?

Thanks and greetz,
Jasper

i don't understand. what do you mean by "when i put the SD card in a floppydisc cable" ?

[freshworks]

Hi Jeff,

i mean i don't have a SD card socket at the moment and used this sollution:



So now i don't have the:

SD_WR_PROTECT and SD_PRESENT connections and the standalone always says no card detected.

Cheers,
Jasper

[Jeff]

Hi Jeff,

i mean i don't have a SD card socket at the moment and used this sollution:



So now i don't have the:

SD_WR_PROTECT and SD_PRESENT connections and the standalone always says no card detected.

Cheers,
Jasper

SD_WR_PROTECT and SD_PRESENT are not used by the firmware. the firmware try to initialize the sdcard to check its presence.

[freshworks]

Hi Jeff,

i've killed an SD cardreader and used the SD slot, now it's working OK.

Thanks,
Jasper

[neverdaie]

excuse me, i have the same problem: " No sd card found_" qu' it was the solution of freshworks?

Thanks