-------------------------------------------------------------------------------
-----------H----H--X----X-----CCCCC-----22222----0000-----0000-----11----------
----------H----H----X-X-----C--------------2---0----0---0----0---1-1-----------
---------HHHHHH-----X------C----------22222---0----0---0----0-----1------------
--------H----H----X--X----C----------2-------0----0---0----0-----1-------------
-------H----H---X-----X---CCCCC-----22222----0000-----0000----11111------------
-------------------------------------------------------------------------------
-- Contact: hxc2001<at>hxc2001.com --------------------- https://hxc2001.com --
-------------------------------------------------------------------------------
HxC Floppy Emulator project
(c) 2006-2019 Jean-Franois DEL NERO / (c) HxC2001
Forum    : http://torlus.com/floppy/forum
Facebook : https://www.facebook.com/groups/hxc2001
Stores   : https://hxc2001.com/store/  https://lotharek.pl/
-------------------------------------------------------------------------------

QX3 SD HxC and HxC-Gotek Floppy emulators working setup :

--------------------------------------------------------------------

Specific for the Gotek :

Get a custom firmware with version >= v3.1.60.4a or use the firmware present in the gotek_hxc_fw folder.

https://hxc2001.com/custom_fw/

check the "Non gated mode" checkbox,
Set "Motor input line" to "Floppy Select Line".
Set "Motor ON - Ready delay" to 400ms".

Leave all others parameters as default.

Get and update the firmware.
Once your new firmware is flashed you may need to clear the drive internal settings to use some of your default settings : Press the right button at power up to clear them.

--------------------------------------------------------------------

For the config file (for all SD HxC and Gotek HxC floppy emulators):

-> Start the hxc software,
-> Menu Settings -> SD HxC Floppy Emulator settings
-> In the "SD HxC Emulator Interface setting" set the Drive A config :
   Mode=Custom, Pin 2=nDiskChange 1, Pin 34=nReady,
   check "Drive B input as Drives Motor ON",
   uncheck "2 drives emulation".

If you want to enable the Indexed mode, check "Enable indexed mode"

Save the config file.

(Some ready to be used config files in the "config_files" folder)
--------------------------------------------------------------------

SD HxC rev C/F/Slim switches config : Set ID0-A and ID3-B to ON.

Gotek HxC Jumper config : Place the "MO" jumper, remove all others jumpers.
